Screw connections
Front wheel Value Valid
Quick-release axle in axle holder
M18 x 1.5 30 Nm
Clamping screws (quick-release
axle) in telescopic forks
M6 x 30 Tightening sequence: Tighten screws
six times in alternate sequence
8 Nm
Brake caliper to fork leg
M8 x 32 - 10.9 28 Nm
Rear wheel Value Valid
Rear wheel on output shaft
M10 x 1.25 x 40 Tightening sequence: tighten in diagon-
ally opposite sequence
60 Nm
Silencer to bracket
M8 x 30 19 Nm
11
147
z
Technical data
https://www.motorcycle-manual.com/
To Next Page
Loading...
Need help?
General
