Install securing screws 1 on
left and right and tighten to
specified tightening torque.
Brake caliper to slider
tube
30 Nm
Remove the adhesive tape
from the wheel rim.
Braking efficiency is im-
paired if the brake pads are
not correctly bedded against the
discs.
Before riding off, always check
that the brakes bite as soon as
the brake lever is pulled or the
brake pedal depressed.
Operate the brake several
times until the brake pads are
bedded.
with BMW Motorrad Integral
ABS II
OE
Close the retaining clips hold-
ing the ABS sensor cable to
the brake line.
The cable of the ABS
sensor could chafe through
if it comes into contact with the
brake disc.
Make sure that the ABS sensor
cable is routed correctly.
Make sure that the ABS sensor
cable is routed as shown
here.
Removing rear wheel
Make sure the ground is level
and firm and place the motor-
cycle on its centre stand.
Engage first gear.
Remove studs 1 from the rear
wheel, while supporting the
wheel.
8
122
z
Maintenance
To Next Page
Loading...
Need help?
General
