To Next Page

To Previous Page

Push the two mounts 2 out-

ward, continuing until the front

supension fits between them.

Use locating pins 3 to set front

wheel stand to desired height.

Center front wheel stand rela-

tive to front wheel and push it

against front axle.

Align two mounts 2 so that

front suspension rests securely

on them.

Tighten mounting screw 1.

ATTENTION

Lifting off of the main stand

if the motorcycle is raised

too high.

Component damage caused by

tipping over.

When raising the motorcy-

cle, make sure that the center

stand remains on the ground.

Apply uniform pressure to push

front wheel stand down and

raise motorcycle.

Light sources

Replacing bulbs for low-

beam headlight

NOTICE

The alignment of connector,

spring wire strap and bulb may

differ from that shown in the fol-

lowing illustrations.

Park motorcycle, ensuring that

support surface is firm and

level.

Switch off ignition.

135

Maintenance

ProCarManuals.com

Questions and Answers:

Need help?

Do you have a question about the BMW R 1200RT 2015 and is the answer not in the manual?

BMW R 1200RT 2015 Specifications

General

Displacement	1170 cc
Torque	125 Nm at 6, 500 rpm
Curb Weight	274 kg
Fuel System	Electronic fuel injection
Cooling System	Air/liquid-cooled
Final Drive	Shaft drive
Front Tire	120/70 ZR17
Rear Tire	180/55 ZR17
ABS	Standard
Power	125 hp at 7, 750 rpm
Transmission	6-speed
Fuel Capacity	25 liters
Seat Height	805/825 mm (adjustable)
Front Suspension	Telelever fork
Rear Suspension	Paralever swingarm
Front Brakes	Dual 320 mm discs, 4-piston calipers
Rear Brakes	Single 276 mm disc, 2-piston caliper
Engine Type	Air/liquid-cooled, four-stroke, flat twin