Bosch DIVAR 2000 User Manual

11.2
DIVAR 2000 / DIVAR 3000 / DIVAR
Maintenance | en 77
5000
11
11.1
Maintenance
Insert DIVAR 5000 in rack
1. Remove the four cross head screws (two on each side) located near the front panel on
the right and left side of the unit.
2. Secure the supplied brackets to each side using the same four cross head screws (two on
each side) that were just removed.
3. To install several units directly on top of each other, remove the rubber feet from under
the unit by prying them loose with a small screwdriver.
4. Install the unit into the rack using the hardware supplied with the rack and following the
rack manufacturer’s instructions.
5. Support the back of the unit and secure the connection cables to the rack to relieve
excessive weight to the back of the unit.
Notice!
When installing the assembly into the rack, do not restrict air flow around the vents located
on the side panels or exceed the recommended operating temperature.
Replace internal battery
!
Warning!
Lithium battery:
Batteries that have been inserted wrongly can cause an explosion. Always replace empty
batteries with batteries of the same type or a similar type recommended by the manufacturer.
Handle used batteries carefully. Do not damage the battery in any way. A damaged battery
may release hazardous materials into the environment.
Dispose of empty batteries according to the manufacturer's instructions, or local directives.
Replace internal battery
This product uses a 3.0 V Lithium CR2032 battery as the backup power supply for internal
system status (e.g. real time clock). Under normal circumstances this battery will last a
minimum of 5 years. Low battery power may mean that system time must be reset at each
power up. A log message appears when the battery needs replacing (only replace when
required).
Contact Bosch for replace instructions.
Install HDD
See separate Quick Install Guide.
Refer to the Appendix for recommended HDD types.
Bosch Security Systems Operation Manual 2016.09 | v1.0 | AM18-Q0717
Available from A1 Security Cameras
www.a1securitycameras.com email: sales@a1securitycameras.com
11.3

Bosch DIVAR 2000 Specifications

General

Number of fans	1 fan(s)
Input bandwidth	256 Mbit/s
Number of users	128 user(s)
Recording modes	Manual, Schedule, Stop
Output bandwidth	128 Mbit/s
Maximum resolution	3840 x 2160 pixels
Video input channels	16 channels
Supported resolutions	3840 x 2160, 1920 x 1080, 1280 x 1024, 1280 x 720, 1024 x 768
Video recording modes	720p, 1080p
Video motion detection	Yes
Video formats supported	H.264, H.265, M-JPEG
DC-in jack	No
Disc types supported	DVD, DVD+R, DVD+RW
USB 2.0 ports quantity	USB 2.0 ports have a data transmission speed of 480 Mbps, and are backwards compatible with USB 1.1 ports. You can connect all kinds of peripheral devices to them.
Ethernet LAN data rates	10, 100, 1000 Mbit/s
Ethernet LAN (RJ-45) ports	9
Supported network protocols	HTTP, HTTPS, TCP/IP, IPv4/IPv6, UPnP, RTSP, UDP, SMTP, NTP, DHCP, DNS/DDNS, IP Filter, PPPoE, FTP
Power over Ethernet (PoE) ports quantity	8
HDD capacity	2000 GB
HDD interface	Serial ATA III
Maximum storage capacity	6 TB
AC input voltage	100 - 240 V
AC input frequency	50 - 60 Hz
Total Power over Ethernet (PoE) budget	115 W
Power over Ethernet (PoE) power per port	25.5 W
Storage temperature (T-T)	-40 - 70 °C
Operating temperature (T-T)	0 - 40 °C
Storage relative humidity (H-H)	0 - 95 %
Operating relative humidity (H-H)	0 - 93 %
Mobile operating systems supported	Android, iOS
Sustainability certificates	RoHS
Certification	FCC, UL, CE,
Product color	Black

Weight and Dimensions

Depth	323 mm
Width	375 mm
Height	53 mm