7. USING THE OPERATION PANEL (ADVANCED OPERATIONS)
39
BAS-342G
7-7. Using user programs
Up to 50 different combinations of settings including program no., X-scale, Y-scale, sewing speed and intermittent presser
foot height can be memorized as user programs (U1 to U50).
If you are sewing certain patterns over and over again, it is useful to record the settings for these patterns into a user
program.
User programs are enabled when memory switch no. 400 is set to "ON".
<Recording user programs>
1
Select a user program number.
TEST indicator illuminates, MENU indicator flashes
While pressing the TEST key, press the SELECT key.
• Switch to user program recording mode. Check that
the menu indicators are flashing.
• The user program number will appear in the
PROGRAM No. display, and " P- - - " will appear in the
menu display.
Press the
or key to select the user program
number.
2
First, set the program number.
Press the
or key to set the user program number
to be recorded.
NOTE:
Select a program number that is recorded in the
internal memory. You cannot specify program
numbers on removable media.
3
Next, set the X-scale.
X-SCALE indicator flashes
Press the SELECT key.
Press the or key to set the X-scale to be recorded.
4
Next, set the Y-scale.
Y-SCALE indicator flashes
Press the SELECT key.
Press the or key to set the Y-scale to be recorded.
4469Q
4966Q
4470Q
4472Q
To Next Page
Loading...
Need help?
General
