Troubleshooting
55
7
The indicators show that error 1 has
occurred.
If error 1 persists, check for the following:
You are not using tape longer than 1 m or incompatible file
formats.
When sending a template as a BLF file, an error is indicated
if the model name in the file is different to the model name
of the printer receiving the file.
When trying to print a template, an error is displayed if the
specified template does not exist.
LEDs shows an error if the search for a template with a
linked database fails.
LEDs shows an error if the transferred, data causes the
capacity of the user storage area to be exceeded.
If you get such errors, turn the printer off, and then turn it on
again.
If error 1 is not cleared, contact Brother customer service.
The indicators show that error 2 has
occurred.
Check if the connected device is supported by the USB
port.
An overcurrent or unsupported device was detected by the
USB port. Turn the printer off, and then check the
connected device.
If a USB hub is connected, the printer will automatically turn
off after a certain length of time has passed.
An error is displayed if the file system becomes corrupted
or a file is copied while a mass storage file is being
processed. Turn the printer off.
Check if the wireless LAN or Bluetooth connection been
interrupted. (TD-2125NWB/2135NWB only).
The wireless LAN or Bluetooth connection established
while the printer is on was interrupted. Turn the printer off,
and then turn it on again.
Problem Solution
To Next Page
Loading...
Need help?
General