Canon EOS-1D Mark II Digial User Manual

162
If there is a problem, first refer to this Troubleshooting Guide.
¡ You are using the wrong battery.
s Use the dedicated Ni-MH Pack. (p.18)
¡ The battery is not properly attached to the charger.
s Attach the battery properly to the charger. (p.18)
¡ The battery is exhausted.
s Recharge the battery. (p.18)
¡ The battery is not installed properly.
s Install the battery properly. (p.20)
¡ The memory card slot is open.
s Push in the memory card and close the memory card slot. (p.24)
¡ If you set the <
4> switch to <2> right after shooting, the
access lamp will still light or blink for a few seconds while the
image is recorded onto the memory card.
s When the camera finishes recording the image to the memory
card, the access lamp will stop blinking and the power will turn off.
¡ The battery is not fully charged.
s Recharge the battery fully. (p.18)
¡ The battery’s service life has expired.
s Replace it with a new battery. (p.168)
Troubleshooting Guide
Power Source
The battery cannot be recharged.
The camera does not operate even when the < 4 > switch is set to < 1 >.
The access lamp lights or blinks even when the < 4 > switch is set to < 2 >.
The battery becomes exhausted quickly.

Canon EOS-1D Mark II Digial Specifications

General

Sensor Type	CMOS
Effective Pixels	8.2 megapixels
Sensor Size	28.7 x 19.1 mm
ISO Sensitivity	ISO 100-1600 (expandable to 50-3200)
Autofocus Points	45
Continuous Shooting Speed	8.5 fps
LCD Screen Size	2.0 inches
Weight	1220 g (body only)
Camera Type	Digital SLR
Image Resolution	3504 x 2336
Lens Mount	Canon EF
Viewfinder	Optical (pentaprism)
Battery	NP-E3
Dimensions	156 x 157.6 x 79.9 mm
LCD Screen Resolution	230, 000 pixels
Viewfinder Coverage	100%
Shutter Speed Range	30 - 1/8000 sec
Storage Media	CompactFlash (Type I or II)