Troubleshooting Guide
If there is a problem, first refer to this Troubleshooting Guide. If this
Troubleshooting Guide does not resolve the problem, contact your
dealer or nearest Canon Service Center.
ThecameradoesnotOperat÷evenWhenthe powerSWitChis
set to <ON>.
® The battery, is not properly installed in the camera. (p.26)
® Recharge the battery. (p.24)
® Make sure the battery compartment cover is closed. (p.26)
_, Make sure the card slot cover is close& (p.31)
® Press the <DISP.> button.
The access lamp still blinks even when the power switch is
set to <OFF>.
® if the power is cut off while an image is being recorded to the card, the
access lamp will light/blink for a few sec. After the image is recorded to
the card, the camera turns off automatically.
The battery becomes e×hausted quickJy.
® Use a fu!lyocharged battery. (p.24)
® The rechargeable battery will degrade after repeated use. Purchase a
new one.
The camera turns off by itself.
® Auto power off is in effect. If you do not want auto power off to take
effect, set the It?° Auto power off] menu to [Off].
® Even if [L'?° Auto power off] has been set to [Off], the LCD monitor wil!
turn off after the camera is idle for 30 min. Press the <DISR> button to
turn on the LCD monitor.
172
To Next Page
Loading...
