Canon imageCLASS MF414dw - Firmware Upgrade; Upgrading with the UST; Upgrading Via the Internet

imageCLASS MF410dw Series Service Guide for AS
imageCLASS MF410dw Series Service Guide for AS April 2016
Page 14
E. Firmware Upgrade
The imageCLASS MF410dw Series supports two methods to upgrade the
firmware.
1. UST (User Support Tool)
2. Via the Internet
1. Upgrading with the UST
Firmware is available for download on the Canon USA public Web site
(http://www.usa.canon.com/support). When servicing the machine, make
sure to go to the Canon USA public Web site, and download the most
recent firmware.
Note:
• A computer and the most recent UST (User Support Tool) file are
required to install upgraded firmware.
• Only the Engine Controller PCB can be upgraded using the UST.
• The UST and firmware are included in the firmware package download
from the Canon USA public Web site.
2. Upgrading via the Internet
The imageCLASS MF410 Series firmware can be upgraded without the
use of an external PC.
IMPORTANT
• To upgrade the firmware via Internet, the Serial Number of the machine
must be written on the Main Controller PCB, and the BODY number
must be registered in the Service Mode.
• The machine must also be connected to a network with Internet access.
After the machine’s firmware is updated, the machine restarts and installs
the update. For more information on updating firmware without a PC, see
the imageCLASS MF414dw/MF416dw Service Manual, or the
imageCLASS MF419dw Service Manual.