imageCLASS MF410dw Series Service Guide for AS
imageCLASS MF410dw Series Service Guide for AS April 2016
Page 19
K. Soft Counters (imageCLASS MF419dw Only)
The imageCLASS MF419dw machine uses soft counters to track its
functional copy use. The control panel displays up to two counters on the
Counter Status Check screen (when the Counter Check key on the control
panel is pressed). By default, the imageCLASS MF419dw machine displays 2
out of 5 counters on the Counter Status Check screen.
The table below indicates the default counter configurations of the
imageCLASS MF419dw machine that is displayed on the Counter Status
Check screen. For more information on the soft counter configurations, see
the imageCLASS MF419dw Service Manual. Specifically, refer to the Service
Mode section of the Service Manual that covers the setting under COPIER >
OPTION > USER > TNRB-SW.
Table 13 – Soft Counter Configuration
Counter Description
Display
Default Switch
1 101: Total 1 On Fixed
2 201: Copy (Total 1) On
May be changed
via Service Mode
setting to any
available counter.
3 113: Total Black/Small
5
) Off
4 501: Scan (Total 1) Off
5 301: Print (Total 1) Off
The displayed counters can be changed, enabled, or disabled in the Service
Mode, except for Counter 1. Counter 1 cannot be changed under any
circumstances.
Since the imageCLASS MF419dw machine does not support 11” x 17” paper,
the customer cannot use a double-click charge scheme.
5 Refers to small size paper (when the paper length is 14” (364 mm) or shorter in the paper feed direction).