•
If the paper is jammed by the Ejection Guide
Remove the jammed paper from the Output
Tray.
After removing the paper, make sure there are
no other scraps of paper in the printer.
3
Pull the Release Lever forward.
Roll paper cannot be inserted into the paper feed slot
Roll paper cannot be inserted into the paper feed slot
Cause Corrective Action
The roll paper is warped. Straighten out curls and reload the roll.
Paper is jammed by the paper feed slot. Remove the jammed paper.
(See "Clearing Jammed Roll Paper.") →P.84
(See "Clearing a Jammed Sheet.") →P.87
The paper source selection is incorrect. Press the Load button and select the paper source.
Cannot load sheets
Cannot load sheets
Cause Corrective Action
The paper source selection is incorrect. Press the Load button and select the paper source.
Paper is not cut neatly
Paper is not cut neatly
Cause Corrective Action
The paper is bent or curled at the cut position. Straighten out any curling by the edges of the paper.
Paper rises by the ends of the cut position before
it is cut.
Reload the paper correctly.
You are using paper that cannot be cut with the
Cutter Unit.
Specify Manual in Cutting Mode in the Control Panel menu and use scissors or a
cutting tool to cut the roll after printing.
(See "Specifying the Cutting Method for Rolls.") →User's Guide
Cut Speed is not configured correctly in the Con-
trol Panel menu.
Change the Cut Speed setting in the Control Panel menu.
(See "Menu Structure.") →P.48
Roll paper cannot be inserted into the paper feed slot
iPF765
Basic Guide
Troubleshooting Problems Regarding Paper
90
To Next Page
Loading...
Need help?
General
Weight and Dimensions
