Some computers employ special signal formats which may not be tuned by Multi-scan system of this
projector. Manual PC Adjustment enables you to precisely adjust several parameters to match those
signal formats. The projector has 10 independent memory areas to store those parameters manually
adjusted. It allows you to recall the setting for a specific computer.
1
2
Use the Point ◄► buttons to adjust the value,
eliminating a flicker from the image displayed
(from 0 to 31).
Use the Point ◄► buttons to adjust the
number of total dots in one horizontal period to
match your PC image.
Use the Point ◄► buttons to adjust the
horizontal picture position.
Use the Point ◄► buttons to adjust the
vertical picture position.
Use the Point ◄► buttons to adjust the clamp
level. When the image has dark bars, try this
adjustment.
Press the MENU button to display the
On-Screen Menu. Use the Point ▲▼
buttons to select and then
press the Point ► or the OK button.
Use the Point ▲▼ buttons to select the
desired item and then press the OK button
to display the adjustment dialog box. Use
the Point ◄► buttons to adjust the setting
value.
Use the Point ◄► buttons to adjust the vertical
area displayed by this projector.
Use the Point ◄► buttons to adjust the
horizontal area displayed by this projector.
Press the OK button to show and
of the connected computer.
• cannot be selected when , 575i, , , , 1035i or is selected in the
PC System Menu (p.31).
To Next Page
Loading...
Need help?
General
