174
Other Settings (SETTING)
Procedure
[MENU] * “¥ SETTING” Tab * Auto Rotate
This setting can be used to configure the camera to display playback images in the
same orientation as the camera when the image was shot.
Procedure
[MENU] * “¥ SETTING” Tab * File No.
Use the following procedure to specify the rule that governs generation of the serial
number used in file names (page 168).
Auto Image Orientation Detection and Rotation (Auto Rotate)
On
Rotates the displayed image in accordance with the camera
orientation when the image was recorded.
Off Images not rotated automatically.
Specifying the File Name Serial Number Generation Rule
(File No.)
Continue
Tells the camera to remember the last used file number. A new file
will be named using the next sequential number, even if files are
deleted or if a blank memory card is loaded. If a memory card is
loaded and that card already has files stored on it and the largest
sequential number in the existing file names is greater than the
largest sequential number remembered by the camera, numbering of
new files will start from the largest sequential number in the memory
card file names plus 1.
Reset
Restarts the serial number from 0001 whenever all files are deleted
or when the memory card is replaced with a blank one. If a memory
card is loaded and that card already has files stored on it, numbering
of new files will start from the largest sequential number in the
memory card file names plus 1.
To Next Page
Loading...
Need help?
General
