166
EDITING IMAGES
8. When the frame where you want the second
(To) cut point to be is displayed, press [T].
9. In response to the confirmation message that
appears, use [S] and [T] to select “Yes” and
then press [SET].
• To cancel movie editing, select “No” instead of “Yes” and
then press [SET]. This will return to the paused movie
playback screen.
• The selected cut operation will take considerable time to
complete. Wait until the “Busy... Please wait...” message
disappears from the monitor screen before performing
any operation on the camera. Note that a cut operation
can take a very long time if the movie being edited is long.
MOTION PRINT lets you capture a movie frame and use it to
create a snapshot. The snapshot you create can be either of the
two formats described below.
Creating a Snapshot of a Movie Frame
(MOTION PRINT)
9-frame Snapshot
(2M 1600 × 1200
pixels)
This format puts the selected movie
frame in the center, the four frames that
precede it along top and the four frames
that follow it along the bottom.
To Next Page
Loading...
Need help?
General
