BASIC IMAGE RECORDING
59
[
왔
] ( )
Flash mode indicator
Using the Flash
Perform the following steps to select the flash mode you
want to use.
• The approximate effective range of the flash is shown
below.
Wide Angle: Approximately 0.4 to 2.6 meters (1.3´ to
8.5´)(ISO Sensitivity: Auto)
Telephoto : Approximately 0.4 to 2.0 meters (1.3´ to
6.6´)(ISO Sensitivity: Auto)
1.
In a REC mode, press [MENU].
2.
Press [왔] ( ) to select the flash mode.
• Each press of [왔] ( ) cycles through the flash
mode settings described below on the monitor
screen.
3.
Record the image.
IMPORTANT!
• The flash unit of this camera fires a number of times
when you record an image. The initial flashes are
pre-flashes, which the camera uses to obtain
information that it uses for exposure settings. The
final flash is for recording. Make sure that you keep
the camera still until the shutter releases.
To do this:
Have the flash fire automatically when
required (Auto Flash)
Turn off the flash (Flash Off)
Always fire the flash (Flash On)
Fire a pre-flash followed by image
recording with flash, reducing the
chance of red-eye in the image (Red-
eye reduction)
In this case, the flash fires automatically
when required
Select this setting:
None
To Next Page
Loading...
Need help?
General
