EN-34
Configuring Settings
To change settings shown in the table below, hold down 3 FUNCTION as you press the indicated keyboard keys.
Other Settings
Setting
Pressing
this key:
Does this:
Touch Button Luminosity
Toggles the touch button luminosity setting between 1 (dim) and
2 (bright).
D7 Toggles the setting between 1 and 2.
Touch Button Sensitivity
Specifies touch button sensitivity within the range of –1 (Low) to
0 (Standard) to +1 (High).
E}7 Lowers the touch button sensitivity setting
by 1.
E7 Raises the touch button sensitivity setting
by 1.
Speaker Out
Controls whether or not sound is output from the speakers when
something is plugged into either of the bk PHONES jacks. Sound is
not output when this setting is disabled (default), and output when it is
enabled.
F7 Toggles between enabled and disabled.
Power On Alert
Enables or disables Power On Alert (page EN-7).
F{7 Toggles between enabled and disabled.
Panel Light Setting
To save power, you can configure a setting that will turn off all button
lights, except for 3 FUNCTION, after a certain period of non-
operation. You can specify a trigger time of 5, 30, 60, or 120 seconds.
You can also disable this setting, which means that lights will remain
on.
G7 See “To change the panel light setting”
(page EN-35).
Auto Resume
Enabling Auto Resume causes most settings to be saved while power
is turned off.*
1
A}7 Toggles between enabled and disabled.
Notification Tone Volume
The notification tone volume can be adjusted within the range of
0 (muted) to 10 (maximum).
A7 Lowers the notification tone volume by 1.
B}7 Raises the notification tone volume by 1.
A7 + B}7 Returns the notification tone volume to its
initial default setting.
Notification Tone Set Selection
Your Digital Piano lets you know the results of operations by sounding
notification tones. You can select from among three different notification
tone sets.
B7 Cycles the setting to the next notification
tone set (1, 2, 3).
A0
C8
F7: Speaker Out
F{7: Power On Alert
G7: Panel Light Setting
A}7: Auto Resume
A7: Notification Tone Volume (–)
B}7: Notification Tone Volume (+)
B7: Notification Tone Set Selection
C8: Panel Lock
E7: Touch Button Sensitivity (+)
E}7: Touch Button Sensitivity (–)
D7: Touch Button Luminosity
To Next Page
Loading...
Need help?
General
