R-62
Application System
2-10-2. Clock-in operation
This function is used to register the Starting work time. If the total worktime is greater than the daily/ weekly
programmed time, minor employee cannot be clocked in. (Error 169 occurs) In this case, clock-in by manager.
2-10-2-1. Clock-in operation (1)
Program: Not using the window and impossible to specify job code.
Allow to specify job code = NO, Display job code window = NO
(Refer to the page 62 of the programming manual.)
Operation
1. XXXXXX <CLOCK-IN>
When this message appears, press the <YES> key to register
the start of working hours.
XXXXXX
REG 10-10-01 11:59 AM 001234
GLENN DEAL 11:59 AM
Clock-in OK?
0.00
Employee No.
To Next Page
Loading...
Need help?
General
