MOMENT SETTER Notification Function
On the “START” Screen, you can tap to display a screen for configuring
MOMENT SETTER settings that control how notifications of useful
information are
provided to you while engaging in an activity. For details, see
“Using the MOMENT SETTER App”.
Data Displayed During Measurement Operations
Note the points below concerning the data displayed while a measurement
operation is in progress.
●
For information
about procedures to calibrate the barometric pressure and
altitude values displayed by the Activity app to make them more accurate,
read “Common Outdoor Function Settings” and then refer to the following
items: “Barometric Pressure Calibration”, “Altitude Calibration”, and
“Correct Altitude Using Location”.
●
Since
speed
and distance traveled are measured using the watch’s or your
smartphone’s GPS function, location measurement error may result in
measured value error.
●
Speed and distance are calculated at regular intervals, so there may be
some lag before values are displayed.
●
Hyphens
(-)
are displayed in place of the speed and distance readings when
the watch is unable to acquire location information (GPS).
●
Location
information
(GPS) acquisition is not supported while the WSD-F10
is connected with an iPhone, so hyphens (-) are displayed in place of the
speed and distance readings.
EN-39
To Next Page
Loading...
Need help?
General
