5.
At the bottom of the display, tap to toggle it to .
6.
Press the power button to exit the MOMENT SETTER
app.
●
After
performing
the above operation, you need to start up the Activity
app and start a Trekking measurement operation to actually receive
notifications. See “Using the Activity App”.
Note
●
A notification from MOMENT SETTER is deleted automatically after a fixed
amount of time.
●
Since speed measurement, distance traveled measurement, and current
location detection are performed using the watch’s or your smartphone’s
GPS function, there may be some measured value error. Accuracy is
particularly poor in a ravine or canyon, among buildings, indoors, and in
other areas where signal reception is bad.
●
You can disable all MOMENT SETTER settings with a single operation.
After
reading
“Common Outdoor Function Settings”, perform the operation
under “All Off”.
Using the Timepiece App
The Timepiece app enters Timepiece Mode, displays the current time on the
monochrome display, and disables all other non-timekeeping watch
functions. Use this app when you want to cut power consumption to the
absolute minimum and display the current time only.
Important!
●
In Timepiece Mode, apps, location information, Wi-Fi, and smartphone
linking (notification reception, etc.) are all disabled.
●
While the watch is in Timepiece Mode, you will not be able to change any
settings related to the current time and date (time zone auto switching,
smartphone time and date sync, including summer time adjustment, etc.)
To update
the time setting, every couple of days you should exit Timepiece
Mode and establish a connection with a smartphone. If you have a WSD-
F20 or WSD-F20S watch, you can perform GPS Time Calibration to adjust
time settings even if the watch is not connected with a phone.
EN-43
To Next Page
Loading...
Need help?
General
