35
Sub Net Mask
The Sub Net Mask is a method used to encode the IP address for the Ethernet interface. The user should contact his/her
IT department or CEM Corporation prior to any change to the Sub Net Mask.
1. Use the “+/-” keys to highlight “Sub Net Mask.”
2. Press the ENTER key.
3. Use the “+/-” keys to increase or decrease the sub net mask and the ARROW keys to toggle between the different
number settings.
4. Once the sub net mask has been entered, press the ENTER key to accept the value.
Serial Number
The instrument serial number is entered by CEM at the point of manufacture. The serial number should not be altered.
Information
The “Information” page is the 5
th
page that appears after selecting “System Setup” from the “Discover Home” screen. This
page allows the user to view the following information:
Firmware
PS Firmware
Power Supply ID
PC Board
Magnetron Time
Temperature
Temperature Control
Pressure
Vessel
Administrative Functions
The “Administrative Functions” screen consists of two (2) “pages” that allow the user to create, edit, and delete a user and
perform maintenance on the system.
NOTE: Only administrative users can view “Administrative Functions.”
To enter the Administrative Functions screen:
1. Press the HOME key until the “Discover Home” screen appears.
2. Use the “+/-” keys to highlight “Administrative Functions.”
3. Press the ENTER key. A new screen will appear.
To Next Page
Loading...
Need help?
General
