Emergency Procedures
131
order to avoid it affects the
brightness of the bulb. The
lighting system is a safety
component, please pay more
attention on the replacement of it
and ensure that any detail must be
proper in case of replacement.
Get to the Chery’s special service
station to have it repaired, if
necessary.
The position lamp bulb can’t be
replaced. If the bulb fails to work,
please immediately get to the Chery’s
special service station to have it
repaired.
5. Install it in reverse order.
6. After installation, check whether
the lamp works normally.
High-mount stop lamp bulb
The high-mount stop lamp bulb can’t
be replaced. If the bulb fails to work,
please immediately get to the Chery’s
special service station to have it
repaired.
License plate lamp bulb
Installation position: On the top of
license plate.
1. Remove the self-tapping screws
used to fix the license plate lamp,
and take out these screws.
2. Draw out the holder and take out
the bulb damaged.
3. Install the new bulb into the
holder, and then install the holder
well.
4. Use the self-tapping screws to
tighten the lamp.
Internal front/rear ceiling
lamp bulb
1. Turn off the interior lights.
2. Insert the screwdriver into the
gap between the lamp housing
and lampshade, and carefully
take out the lampshade.
3. Replace the bulb, and install the
reflector.
4. Reinstall the lampshade into the
installation hole located on the
lamp housing.
Sun visor mirror light:
Installation position：On the rear of sun
visor.
Take out the mirror and then replace
To Next Page
Loading...
Need help?
General
