Emergency Procedures
139
y There is high voltage in the
electronic ignition system. Please
DO NOT touch these components
when the engine is operating or
the ignition switch turns on.
Removal and Installation
When the removal and installation of
the battery, take the following
countermeasures:
y Your vehicle is equipped with the
12 V 75A•h maintenance-free
lead-acid battery.
y Replace the battery with the
lead-acid one, and DO NOT use
other kinds of batteries. The
current and capacity of new
battery must be the same as that
of old battery or conform the
Chery’s specifications. For the
proper battery specifications,
please contact the Chery’s special
service station.
y After the ignition switch and all
electrical equipment turn off,
please remove the negative (-)
cables first.
y Carefully operate in order to
avoid that the metal tool touches
the both electrical terminals of
batter at the same time or contacts
the positive terminal and vehicle
body by accident.
y When the battery is reconnected,
connect the positive (+) cable,
and then the negative (-) cable.
y After the battery is removed and
reconnected, the performance of
the vehicle may be somewhat
abnormal at the early stage. This
is the engine control system is
readapting the engine. It can’t be
considered.
The used battery contains the
sulphuric acid and lead. DO
NOT dispose them as the common
household waste. Please send them to
the local qualified waste disposal
station.
To Next Page
Loading...
Need help?
General
