Emergency Procedures
140
Engine battery-assisted
start method
If there is no power in the vehicle’s
battery, introduce the power of other
vehicles into the vehicle and help the
engine to start.
Connect the battery of the same
nominal voltage (12V) only. Please use
the jumper wire with the insulating clip,
and the cable with proper dimension.
Please DO NOT remove the low power
battery from the electrical system of the
vehicle.
Connect the down-lead
1. Properly stop these vehicles in
order to avoid that they don’t
touch each other.
2. Extinguish the engine, and turn
off any unnecessary electrical
equipment.
3. Connect the positive (+) terminal
of the low power battery to the
positive (+) terminal of the
support battery via the wire A.
Low Powe
To Next Page
Loading...
Need help?
General
