Interior Device Operation and Adjustment
20
Steering Wheel/
Ignition Switch
The combined steering wheel
lock/ignition switch has following key
positions:
LOCK - Ignition switch is turned off
as the steering wheel is locked.
When the key is pulled out from the
ignition switch, the steering wheel lock
will actuate to lock the steering wheel.
In order to lock the steering wheel,
rotate the steering wheel once after the
withdrawal of the key, till the
engagement sound as the steering
wheel is locked.
ACC – Unlock of steering system.
When the circuits of the electrical
accessories are turned on, the small
electrical appliances such as interior
lamp can be operated, however the
ignition switch and the main electrical
circuits are all turned off.
If it fails or has difficulty to rotate the
key from the LOCK position to such
position, the lock mechanism of the
steering wheel can be released by rotate
the steering wheel around slightly.
The ignition switch key should not be
left at such position overlong so as to
avoid the depletion of the battery
power.
ON – All electrical circuits can operate
once the ignition circuit is turned on.
The alarm lamp and the indicator will
light. This is the normal position of key
during driving as well as the position
must be selected during vehicle towing.
START – Turn on the start motor and
start the engine.
When the key is at such position, the
front headlamp and the electrical
devices with higher power
consumption will be turned off.
The ignition switch is equipped with
repeated start proof device internally.
Once the engine is running, such
device can prevent the mis-start of the
starter so as to avoid the damage to the
starter and the engine flywheel.
If the start fails, then it’s must to rotate
the ignition key to LOCK position
before rotate to this position for restart.
After start, the key will bounce back to
ON position when the key is released
Adjustment of Steering
Wheel
The key must be released
once the engine is started.
Do not hold at the START
position for much longer.