Securing a Child Restraint Designed
for the
LATCH
System
1.
Find the anchors for the seating position you want
to use, where the bottom of the seatback meets the
back of the seat cushion.
2.
Put the child restraint on the seat.
3.
Attach the anchor points on the child restraint
to the anchors in the vehicle. The child restraint
instructions will show you how.
4.
If
the child restraint is forward-facing, attach the top
strap to the top strap anchor. See
Top Strap on
page
1-41.
Tighten the top strap according to
the child restraint instructions.
directions to be sure it is secure.
5.
Push and pull the child restraint in different
To remove the child restraint, simply unhook the top
strap from the top tether anchor and then disconnect the
anchor points.
Securing a
Child
Restraint in a Rear
Outside Seat Position
U
If your child restraint is equipped with the LATCH
system, see
Lower Anchorages and
Top
Tethers
for
Children (LATCH System) on page
1-43.
You’ll be using the lap-shoulder belt. See the earlier
part about the top strap
if
the child restraint has one.
Be sure
to
follow the instructions that came with the child
restraint. Secure the child in the child restraint when
and as the instructions say.
1.
Put the restraint on the seat.
2.
Pick up the latch plate, and run the lap and shoulder
portions
of the vehicle’s safety belt through or
around the restraint. The child restraint instructions
will show you how.
1
-45
To Next Page
Loading...
Need help?
General
