Remote Keyless Entry System
If
equipped, the keyless entry system operates on a
radio frequency subject
to
Federal Communications
Commission (FCC) Rules and with Industry Canada.
This device complies with Part
15
of the FCC Rules.
Operation is subject
to
the following two conditions:
1.
This device may not cause interference, and
2. This device must accept any interference received,
including interference that may cause undesired
operation of the device.
This device complies with
RSS-210
of Industry Canada.
Operation
is
subject to the following two conditions:
1.
This device may not cause interference, and
2. This device must accept any interference received,
including interference that may cause undesired
operation of the device.
Changes or modifications
to
this system by other than
an authorized service facility could void authorization
to
use this equipment.
At
times you may notice a decrease in range. This
is
normal for any remote keyless entry system.
If
the
transmitter does not work or
if
you have to stand closer
to
your vehicle for the transmitter
to
work, try this:
Check the distance. You may be
too
far from your
vehicle. You may need
to
stand closer during
rainy or snowy weather.
Check the location. Other vehicles or objects may
be blocking the signal. Take a few steps to the
left or right, hold the transmitter higher, and
try again.
Check
to
determine
if
battery replacement
is
necessary. See
“Battery Replacement”
under
Remote Keyless Entry System Operation on
page
2-5.
If
you are still having trouble, see your dealer or a
qualified technician for service.
2-4
To Next Page
Loading...
Need help?
General
