Step 2 Press Continue.
The Continue softkey doesn't appear until you enter first three digits of the valid activation code
followed by a # key. The Delete softkey appears only when you enter the first digit of activation
code in the Enter activation code box.
Note
The phone completes the provisioning process automatically.
Step 3 If an error message displays, enter the code again or contact your administrator.
Set a Password on Initial Phone Boot Up
The first time your phone boots up, you may be prompted to set a password. If you are not prompted, your
administrator has created a password for you.
Procedure
Step 1 Enter your password in the New password and Reenter new password fields.
Step 2 Press Save.
User Authentication Control
Your administrator can configure if you require authentication to access phone menus. Your administrator
can also customize and turn off the authentication to allow access to all phone menus.
With this feature, whether any phone menu needs authentication is controlled by your administrator. If your
administrator configures authentication to access the menu, you need to provide the password and sign in to
access the menu.
Sign into Your Extension from Another Phone (Extension
Mobility)
If extension mobility is configured, you can sign into a different phone in your network and have it act the
same as your phone. After you sign in, the phone adopts your personal directory number.
Before you begin
Your administrator configures provisioning authority.
Procedure
Step 1 Press Sign in.
Step 2 Enter your username and password, then press Sign in.
Cisco IP Phone 7800 Series Multiplatform Phones User Guide
13
Your Phone
Set a Password on Initial Phone Boot Up
To Next Page
Loading...
Need help?
General
