Cisco 7911G - IP Phone VoIP User Manual

Chapter 1 An Overview of the Cisco Unified IP Phone
Overview of Configuring and Installing Cisco Unified IP Phones
1-26
Cisco Unified IP Phone 7906G and 7911G for Cisco Unified Communications Manager 6.0
OL11954-01
Overview of Configuring and Installing
Cisco Unified IP Phones
When deploying a new Unified Communications system, system administrators
and network administrators must complete several initial configuration tasks to
prepare the network for Unified Communications service. For information and a
checklist for setting up and configuring a complete Cisco Unified
Communications network, refer to the “System Configuration Overview” chapter
in the Cisco Unified Communications Manager System Guide.
After you have set up the Unified Communications system and configured
system-wide features in Cisco Unified Communications Manager, you can add IP
phones to the system.
The following topics provide an overview of procedures for adding
Cisco Unified IP Phones to your network:
• Configuring Cisco Unified IP Phones in Cisco Unified Communications
Manager, page 1-26
• Installing Cisco Unified IP Phones, page 1-32
Configuring Cisco Unified IP Phones in Cisco Unified
Communications Manager
To add phones to the Cisco Unified Communications Manager database, you can
use:
• Auto-registration
• Cisco Unified Communications Manager Administration
• Bulk Administration Tool (BAT)
• BAT and the Tool for Auto-Registered Phones Support (TAPS)
For more information about these choices, see the “Adding Phones to the
Cisco Unified Communications Manager Database” section on page 2-12.

Cisco 7911G - IP Phone VoIP Specifications

General

Brand	Cisco
Model	7911G - IP Phone VoIP
Category	IP Phone
Language	English