Cisco 7911G - IP Phone VoIP User Manual

Chapter 1 An Overview of the Cisco Unified IP Phone
Overview of Configuring and Installing Cisco Unified IP Phones
1-32
Cisco Unified IP Phone 7906G and 7911G for Cisco Unified Communications Manager 6.0
OL11954-01
Installing Cisco Unified IP Phones
After you have added the phones to the Cisco Unified Communications Manager
database, you can complete the phone installation. You (or the phone users) can
install the phone at the users’s location. The Cisco Unified IP Phone Installation
Guide that ships in the box with each phone provides directions for connecting the
phone footstand, handset, cables, and other accessories.
Note Before you install a phone, even if it is new, upgrade the phone to the current
firmware image. For information about upgrading your phone, see the Readme
file for your phone model located at:
http://www.cisco.com/cgi-bin/tablebuild.pl/ip-7900ser
After the phone is connected to the network, the phone startup process begins and
the phone registers with Cisco Unified Communications Manager. To finish
installing the phone, configure the network settings on the phone depending on
whether you enable or disable DHCP service.
If you used auto-registration, you need to update the specific configuration
information for the phone such as associating the phone with a user, changing the
button table, or directory number.
Checklist for Installing the Cisco Unified IP Phones 7906G and 7911G
Table 1-7 provides an overview and checklist of installation tasks for the
Cisco Unified IP Phone 7906G and 7911G. The list presents tasks in a suggested
order to guide you through the phone installation process. Some tasks are
optional, depending on your system and user needs. For detailed procedures and
information, refer to the sources in the list.

Cisco 7911G - IP Phone VoIP Specifications

General

Brand	Cisco
Model	7911G - IP Phone VoIP
Category	IP Phone
Language	English