5
Adjusting the Footstand / Handset Rest
Footstand - To change the angle at which your phone sits on your desktop, adjust the
footstand while pressing the footstand button.
Handset Rest - When you connect your phone, you might want to adjust the handset
rest to ensure that the receiver will not slip out of the cradle. See the table below for
instructions.
1
Set the handset aside and pull the square plastic tab from the handset rest.
2
Rotate the tab 180 degrees.
3
Slide the tab back into the handset rest. An extension protrudes from the top of the rotated
tab. Return the handset to the handset rest.
Signing In to Your Phone
After your phone is connected to the network, your phone may require login infor-
mation prior to allowing you to make or receive calls. If this is the case, your phone
will display “Log In” on the second line of the screen of the phone. To log in to
your phone, use the numeric keypad to enter your 10-digit phone number, User ID,
or global extension number as provided by your service provider in the UID/Phone#
eld. Then, use the teal colored scroll button to move the blinking cursor to the PIN
Code eld. Do this by pressing the lower (down) half of the up-down scroll button.
Then, enter your PIN Code as provided by your system administrator. Unless you
have been otherwise notied, your PIN Code is often the last 4 digits of your phone
number or extension. After you have entered your all information press [Submit].
Your phone will then start the log in process.
Choosing the Proper Headset
Your phone system supports a number of third party headsets. Users are advised
to test a variety of headsets for performance for a few days prior to purchasing and
deploying large numbers of a given headset.
To Next Page
Loading...
Need help?
General
