Cisco ASR 1001-HX User Manual

Step 2
Use two screws to attach the fan trays to the chassis.
Step 3
Plug the four fan connectors into the motherboard.
Step 4
Replace the Cisco ASR 1002-HX Router top cover:
a) Slide the cover onto the chassis ensuring that the interlock hook feature fits on the chassis cover and base.
b) Install the top surface screws, the rear screws, and the side screws and tighten them slightly.
Step 5
Install the power supplies into the chassis and power up the router. See:
•
Installing AC Power Supplies
•
Installing DC Input Power Supplies
Installing the Crypto Module
Installing the Crypto Module in a Cisco ASR 1001-HX Router
Before You Begin
Perform the following steps before you begin the process of installing the crypto module in a Cisco ASR
1001-HX Router:
•
Shut down the router. Enter the copy running-config startup-config command to save the configuration
to NVRAM.
•
Use an ESD-preventive wrist strap.
•
Remove the power supplies before you remove the chassis top cover.
Cisco ASR 1001-HX Router and Cisco ASR 1002-HX Router Hardware Installation Guide
140
Removing and Replacing FRUs
Installing the Crypto Module

Cisco ASR 1001-HX Specifications

General

Brand	Cisco
Model	ASR 1001-HX
Category	Network Router
Language	English