Cisco ASR 1001-HX User Manual

Figure 26: Cisco ASR 1002-HX Router Installed on a Two-Post Equipment Rack
Rack mount bracket ear and screws2Rack equipment rail1
What to Do Next
This completes the procedure for installing the chassis on a two-post rack. Proceed to the “Attaching a Chassis
Ground Connection” section to continue the installation.
Four-Post Rack Installation
Procedure
Step 1
(Optional) Install a shelf in the rack to support the Cisco ASR 1001-HX Router or Cisco ASR 1002-HX
Router. If you use a shelf, it helps support the chassis while you secure it to the rack.
If you are using a shelf, place the chassis on the shelf and slightly raise the front of the chassis to
align the mounting bracket holes with the rack post holes while allowing the bottom of the chassis
to rest on the shelf.
Note
Step 2
With two people, lift the chassis into position between the rack posts.
Step 3
Position the chassis until the rack-mounting flanges are flush against the mounting rails on the rack.
Cisco ASR 1001-HX Router and Cisco ASR 1002-HX Router Hardware Installation Guide
59
Installing the Router
Four-Post Rack Installation

Cisco ASR 1001-HX Specifications

General

Brand	Cisco
Model	ASR 1001-HX
Category	Network Router
Language	English