Cisco ASR 1001-HX User Manual

Step 6
Enter an enable password that is different from the enable secret password. This password is not encrypted
(and is less secure) and can be seen when viewing the configuration.
The enable password is used when you do not specify an
enable secret password, with some older software versions, and
some boot images.
Enter enable password: cisco123
Step 7
Enter the virtual terminal password, which prevents unauthenticated access to the router through ports other
than the console port:
The virtual terminal password is used to protect
access to the router over a network interface.
Enter virtual terminal password: cisco
Step 8
Respond to the following prompts as appropriate for your network:
Configure SNMP Network Management? [no]: yes
Community string [public]:
A summary of the available interfaces is displayed. The interface summary includes interface numbering,
which is dependent on the router model and the installed modules and interface cards.
Current interface summary
Interface IP-Address OK? Method Status Protocol
GigabitEthernet0/0/0 unassigned YES unset down down
GigabitEthernet0/0/1 unassigned YES unset up up
GigabitEthernet0/0/2 unassigned YES unset down down
GigabitEthernet0/0/3 unassigned YES unset up up
GigabitEthernet0/0/4 unassigned YES unset up up
GigabitEthernet0/0/5 unassigned YES unset down down
GigabitEthernet0/0/6 unassigned YES unset up up
GigabitEthernet0/0/7 unassigned YES unset up up
Te0/1/0 unassigned YES unset down down
Te0/1/1 unassigned YES unset down down
Te0/1/2 unassigned YES unset down down
Te0/1/3 unassigned YES unset down down
Te0/1/4 unassigned YES unset up up
Te0/1/5 unassigned YES unset down down
Te0/1/6 unassigned YES unset up up
Te0/1/7 unassigned YES unset down down
GigabitEthernet0 unassigned YES unset up up
Any interface listed with OK? value "NO" does not have a valid configuration
Step 9
Respond to the following prompts as appropriate for your network:
Configuring interface GigabitEthernet0/0/1:
Configure IP on this interface? [yes]: yes
IP address for this interface [10.10.10.12]:
Subnet mask for this interface [255.0.0.0] : 255.255.255.0
Class A network is 10.0.0.0, 24 subnet bits; mask is /24
Cisco ASR 1001-HX Router and Cisco ASR 1002-HX Router Hardware Installation Guide
76
Power Up and Initial Configuration
Using the Cisco setup Command Facility

Cisco ASR 1001-HX Specifications

General

Brand	Cisco
Model	ASR 1001-HX
Category	Network Router
Language	English