Cisco ASR 1002-HX User Manual

Wiring the DC Input Power Source
Statement 1046—Installing or Replacing the Unit
When installing or replacing the unit, the ground connection must always be made first and disconnected
last.
Warning
Procedure
Step 1
Turn off the circuit breaker from the power source.
Step 2
Ensure that the chassis power switch is in the Standby position.
It is not required to place the power switch in the Standby position if you want to hot-swap a single
power supply.
Note
Step 3
Remove the plastic cover from the terminal block.
Before you continue to install the terminal block ground wires, stop and perform Step
4.
Caution
Cisco ASR 1001-HX Router and Cisco ASR 1002-HX Router Hardware Installation Guide
115
Removing and Replacing FRUs
Installing DC Input Power Supplies

Cisco ASR 1002-HX Specifications

General

Brand	Cisco
Model	ASR 1002-HX
Category	Network Router
Language	English