Cisco ASR 1002-HX User Manual

CHAPTER 5
Power Up and Initial Configuration
This chapter guides you through a basic router configuration, which is sufficient for you to access your
network. Complex configuration procedures are beyond the scope of this publication and can be found in
the modular configuration and modular command reference publications in the Cisco IOS software
configuration documentation set that corresponds to the software release installed on your Cisco hardware.
•
Checking Conditions Prior to System Startup, page 71
•
Powering Up the Router, page 72
•
Performing the Initial Configuration on the Router, page 74
•
Saving Your Router Configuration, page 84
•
Verifying the Initial Configuration, page 84
•
Powering Off the Router Safely, page 85
•
Environmental Monitoring and Reporting Functions, page 85
Checking Conditions Prior to System Startup
Ensure that all the card slots and compartments are closed. Install blank faceplates on empty slots. Always
have power supply slots filled. If you leave a power supply slot uncovered, then you risk exposure to hazardous
voltages on the power pins on the midplane.
Statement 1029—Blank Faceplates and Cover Panels
Blank faceplates and cover panels serve three important functions: they prevent exposure to hazardous
voltages and currents inside the chassis; they contain electromagnetic interference (EMI) that might disrupt
other equipment; and they direct the flow of cooling air through the chassis. Do not operate the system
unless all cards, faceplates, front covers, and rear covers are in place.
Warning
To view the boot sequence, you must have a console connection to the Cisco ASR 1001-HX Router or
Cisco ASR 1002-HX Router before it powers up.
Note
Cisco ASR 1001-HX Router and Cisco ASR 1002-HX Router Hardware Installation Guide
71

Cisco ASR 1002-HX Specifications

General

Brand	Cisco
Model	ASR 1002-HX
Category	Network Router
Language	English