•
Refer to VLAN-Related CLI Commands , on page 239 for additional information.
•
Save your configuration as described in the Verifying and Saving Your Configuration chapter.
Configuring Subscriber VLAN Associations
Subscriber traffic can be routed to specific VLANs based on the configuration of their user profile. This
functionality provides a mechanism for routing all traffic from a subscriber over the specified VLAN. All
packets destined for the subscriber must also be sent using only IP addresses valid on the VLAN or they will
be dropped.
RADIUS Attributes Used
The following RADIUS attributes can be configured within subscriber profiles on the RADIUS server to
allow the association of a specific VLAN to the subscriber:
•
SN-Assigned-VLAN-ID: In the Starent VSA dictionary
•
SN1-Assigned-VLAN-ID: In the Starent VSA1 dictionary
Since the instructions for configuring subscriber profiles differ between RADIUS server applications, this
section only describes the individual attributes that can be added to the subscriber profile. Please refer to
the documentation that shipped with your RADIUS server for instructions on configuring subscribers.
Important
Configuring Local Subscriber Profiles
Use the configuration example below to configure VLAN associations within local subscriber profiles on the
system.
These instructions assume that you have already configured subscriber-type VLAN tags according to the
instructions provided in Creating VLAN Tags, on page 236.
Important
config
context context_name
subscriber name user_name
ip vlan vlan_id
end
Verify the Subscriber Profile Configuration
Use the following command to view the configuration for a subscriber profile:
[local]host_name# show subscriber configuration username user_name
Notes:
ASR 5500 System Administration Guide, StarOS Release 21.5
238
VLANs
Configuring Subscriber VLAN Associations
To Next Page
Loading...
Need help?
General
