Cisco ASR 5500 System Administration Guide

For additional NSO information, refer to the NSO user documentation.
Figure 18: NETCONF System Flow
Configuring ConfD
To enable NETCONF protocol in StarOS, you must enable server confd and enter the NETCONF Protocol
Configuration mode. The NETCONF Protocol Configuration mode supports optional configuration commands.
SSH Key Requirement
NETCONF-ConfD support requires that a V2-RSA SSH key be configured on the local context.
If an SSH key is not available, StarOS generates an error message.
Failure: The ConfD (NETCONF) server requires an RSA key on the local context
You can run the show ssh key command to verify the existence of an SSH key on the system.
If an SSH key is not available, see the Configuring SSH Options section of the Getting Started chapter in this
guide.
ASR 5500 System Administration Guide, StarOS Release 21.5
340
NETCONF and ConfD
Configuring ConfD

Cisco ASR 5500 Specifications

General

Brand	Cisco
Model	ASR 5500
Category	Network Router
Language	English