Cisco ASR 5500 System Administration Guide

save configuration <url> confd
The keyword confd is added to the Exec mode save configuration command. This keyword filters the saved
configuration commands to contain only configuration commands that are supported by the YANG model.
The command syntax for this process is:
[local]host_name# save configuration <url> confd
The output of the YANG model subset of configuration commands can be viewed via the show file url <url>
command, where <url> is the pathname used to save the configuration. The saved configuration file can then
be applied to the CDB using the configure confd command.
Supported StarOS ECS Configuration Commands
For this release, the following StarOS ECS commands are supported for the CLI based YANG model:
•
ruledef <ruledef_name>
•
ip server-ip-address = *
•
tcp-ether-port = *
•
udp ether-port = *
•
tcp either-port-range = *
•
udp ether-port range = *
•
tcp-any-match = *
•
udp any-match = *
•
http url = *
•
httpcookie = *
•
http x-header = *
•
group-of-ruledefs <ruledefs_group_name>
•
add-ruledef priority = *
•
qos-group-of-ruledefs <group_name>
◦
add-group-of-ruledef <group_of_ruledef_name>
•
charging-action <charging_action_name>
◦
flow-idle-timeout <seconds>
◦
content-id 1
◦
service-identifier <service_id>
◦
billing-action egcdr
•
rulebase <rulebase_name>
ASR 5500 System Administration Guide, StarOS Release 21.5
361
NETCONF and ConfD
Supported StarOS ECS Configuration Commands

Cisco ASR 5500 Specifications

General

Brand	Cisco
Model	ASR 5500
Category	Network Router
Language	English