CHAPTER
4-1
Cisco ASR-920-24SZ-IM, ASR-920-24SZ-M, ASR-920-24TZ-M Aggregation Services Router Hardware Installation Guide
4
Initial Configuration
This chapter guides you through a basic router configuration, which is sufficient for you to access your
network. Complex configuration procedures are beyond the scope of this publication and can be found
in the modular configuration and modular command reference publications in the Cisco IOS software
configuration documentation set that corresponds to the software release installed on your Cisco
hardware.
To configure a Cisco ASR 920-24SZ-IM, ASR-920-24SZ-M, ASR-920-24TZ-M Router from a console,
connect a terminal to the router console port.
This chapter contains the following sections:
• Checking Conditions Prior to System Startup, page 4-1
• Powering Up the Router, page 4-2
• Configuring the Router at Startup, page 4-8
• Safely Powering Off the Router, page 4-10
Checking Conditions Prior to System Startup
Ensure that the following conditions are addressed before starting up the router:
• The optional Gigabit Ethernet Management port cable is installed.
• The chassis is securely mounted and grounded.
• The power and interface cables are connected.
• Your PC with terminal emulation program (HyperTerminal or equivalent) is connected to the
console port and powered up.
• Your PC terminal emulation program is configured for 9600 baud, 8 data bits, 1 stop-bit, no parity,
and no flow control is set to none.
• You have selected passwords for access control.
• Captive installation screws are tight on all the removable components.
• The console terminal is turned on.
• You have determined the IP addresses for the Ethernet and serial interfaces.
To Next Page
Loading...
Need help?
General
