Cisco C20 TelePresence System User Manual

D14637.10 Profile C20 and Quick Set C20 Administrator Guide TC6.1, APRIL 2013. www.cisco.com — Copyright © 2010-2013 Cisco Systems, Inc. All rights reserved.
109
Cisco TelePresence System Quick Set C20 and Profiles using C20 Administrator Guide
HDMI 1 (the default connector for the main monitor)
HDMI 2*
About monitors
Connecting the main monitor
The main monitor can be connected to video output HDMI 1
(the default connector for the main monitor) or HDMI 2*.
The codec will read the native resolution of the monitor and
output this if possible. Typically this will give the best possible
picture for the connected monitor. If auto fails, you will have
to select the resolution manually using the Video > Output >
HDMI n > Resolution settings.
Connecting to HDMI 1
When connecting the main monitor to HDMI 1 the menu,
icons and other information on screen (OSD - on screen
display) will be displayed on the monitor automatically. This is
because HDMI 1 is the default video output of the codec.
Connecting to HDMI 2
When connecting the main monitor to the HDMI 2* output,
the menus, icons and other information are not automatically
displayed on screen. You must move the OSD to the chosen
output.
There is no audio on HDMI 2.
Dual monitors
Requires the Dual Display option.
When you want to run a dual monitor setup, connect the main
monitor to video output HDMI 1 and the second monitor to
video output HDMI 2 on the codec.
Dual monitor configuration
To distribute the layout on the two monitors, go to
Advanced configuration (menu on screen) or open the
System Configuration page (web interface). Then go to
Video > Monitors and choose Dual.
* Use of HDMI 2 requires the Dual Display option.
Moving the OSD
You can move the OSD using the remote control or the web
interface.
Remote control
Check which connector the main monitor is connected to,
and run the following key sequence on the remote control.
• Disconnect * # * # 0 x # x=1 (HDMI 1) x=2 (HDMI 2)
Example: Setting HDMI 2 as the OSD output.
– * – # – * – # – 0 – 2 – #
Web interface
Open the System Configuration page. Go to
Video > OSD > Output and choose the video output
connector for the main monitor.
The video outputs of Codec C20
Contents
Introduction
Web interface
System settings
Setting passwords
AppendicesAppendices

Cisco C20 TelePresence System Specifications

General

Brand	Cisco
Model	C20 TelePresence System
Category	Conference System
Language	English