Cisco cBR User Manual

Step 3
Repeat Step 1, on page 54 and Step 2, on page 57 for the cables connected to the each Supervisor PIC.
Using the USB Port on the Supervisor Card
Before You Begin
•
Install the Supervisor PIC.
•
Install the Supervisor Card.
Restrictions
The USB ports on the Supervisor Card are used for temporary connections. For all permanent connections,
you must use the ports on the Supervisor PIC.
Required Tools and Equipment
•
Memory stick or flash drive
Step 1
Open the tethered I/O door on the Supervisor Card by pulling on the left edge of the door until the door is released from
the spring-loaded ejector.
Figure 24: Opening the Tethered I/O Door on the Supervisor Card
—
Tethered I/O door1
Cisco Converged Broadband Routers Hardware Installation Guide
27
Installing the Supervisor in the Cisco cBR Chassis
Using the USB Port on the Supervisor Card

Cisco cBR Specifications

General

Brand	Cisco
Model	cBR
Category	Network Router
Language	English