EasyManuals Logo
Home>Cisco>Network Router>CRS-1 - Carrier Routing System Router

Cisco CRS-1 - Carrier Routing System Router Hardware Installation Guide

Cisco CRS-1 - Carrier Routing System Router
104 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #46 background imageLoading...
Page #46 background image
3-20
Cisco CRS-1 Carrier Routing System SIP and SPA Hardware Installation Guide
OL-17439-01
Chapter 3 Overview: Cisco CRS-1 Shared Port Adapters
2-Port and 4-Port OC-48c/STM-16 POS/RPR SPA Overview
Table 3-10 describes the 2-Port and 4-Port OC-48c/STM-16 POS/RPR SPA LEDs.
2-Port and 4-Port OC-48c/STM-16 POS/RPR SPA Interface Specifications
The physical layer interface for the 2-Port and 4-Port OC-48c/STM-16 POS/RPR SPA is Optical
Carrier-48 (OC-48), which provides SONET and SDH network connectivity with a per-port bandwidth
of 2.488 Gbps.
Each port on the 2-Port and 4-Port OC-48c/STM-16 POS/RPR SPA has one duplex LC-type receptacle
that allo
w
s connection to single-mode optical fiber.
Note For Cisco IOS XR Software Release 3.8.0, the 2-Port and 4-Port OC-48c/STM-16 POS/RPR SPA
supports Dynamic Packet Transport (DPT) feature. Cisco DPT family of products delivers scalable
Internet service, reliable IP-aware optical transport, and simplified network operations. The Spatial
Reuse Protocol (SRP) is a MAC-layer protocol developed by Cisco and is used in conjunction with Cisco
DPT products, which utilizes a pair of counter-rotating rings in an optimum fashion to provide improved
bandwidth utilization over an equivalent SONET network.
Ta b l e 3-10 2-Port and 4-Port OC-48c/STM-16 POS/RPR SPA LEDs
LED Label Color State Meaning
PTH Off Off Port is not in pass-through mode.
Green On Port
is in pass-through mode.
CAR Off Off Port is not enabled by software.
Green On Port is enabled by software, and there is a v
a
lid
SONET signal without any alarms.
Amber On Port is enabled by software, and there is at least
one alarm.
Amber Flashing Port is enabled by softwar
e
, and there is a side
mismatch.
PRT Off Off Port is not wrapped or steering.
Green On A node on the ring is wrapped.
Green Flashing A node on the ring is steering.
Amber On Port is locally wrapped.
Amber Flashing Port is locally steering.
ACT Off Off Port is not enabled by software.
Green On Port is enabled by software, and loopback is off.
Amber On Port is enabled by software, and loopback is on.
STATUS Off Off SPA power is off.
Green On SPA is ready and operational.
Amber On SPA power is on and good, and the SPA is being
co
nf
igured.

Table of Contents

Other manuals for Cisco CRS-1 - Carrier Routing System Router

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco CRS-1 - Carrier Routing System Router and is the answer not in the manual?

Cisco CRS-1 - Carrier Routing System Router Specifications

General IconGeneral
BrandCisco
ModelCRS-1 - Carrier Routing System Router
CategoryNetwork Router
LanguageEnglish

Related product manuals