Cisco CRS-1 - Carrier Routing System Router Hardware Installation Guide

7-3
Cisco CRS-1 Carrier Routing System SIP and SPA Hardware Installation Guide
OL-17439-01
Chapter 7 Troubleshooting the Installation
Using debug Commands
Using debug Commands
The debug spa command is intended for use by Cisco Systems technical support personnel.
Debugging output is assigned high priority in the CPU process and, therefore, can affect system
p
erformance. For more information about the impact on system performance when using debug
commands, refer to Using Debug Commands on Cisco IOS XR Software.
Step 5
end
or
commit
Example:
RP/0/RP0/CPU0:router(config)# end
or
RP/0/RP0/CPU0:router(config)# commit
Saves configuration changes.
• When you issue the end command, the system prompts
you to commit changes:
Uncommitted changes found, commit them before
exiting(yes/no/cancel)?
[cancel]:
– Entering yes saves configuration changes to the
running configuration file, exits the configuration
session, and returns the router to EXEC mode.
– Entering no exits the configuration session and
returns the router to EXEC mode without
committing the configuration changes.
– Entering cancel leaves the router in the current
configuration session without exiting or
committing the configuration changes.
• Use the commit command to save the configuration
changes to the running configuration file and remain
within the configuration session.
Command or Action Purpose

Cisco CRS-1 - Carrier Routing System Router Specifications

General

Brand	Cisco
Model	CRS-1 - Carrier Routing System Router
Category	Network Router
Language	English