EasyManuals Logo
Home>Cisco>Network Router>CRS-1 - Carrier Routing System Router

Cisco CRS-1 - Carrier Routing System Router Hardware Installation Guide

Cisco CRS-1 - Carrier Routing System Router
104 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #9 background imageLoading...
Page #9 background image
ix
Cisco CRS-1 Carrier Routing System SIP and SPA Hardware Installation Guide
OL-17439-01
Preface
Organization
This document contains the following chapters:
OL-7113-03 October 2006 Information was added to Chapte
r 3, “Overview: Cisco CRS-1
Shared Port Adapters, about the following SPAs:
2-Port and 4-Port OC-48c/STM-16 POS SPA
5-Port Gigabit Ethernet SPA
10-Port Gigabit Ethernet SPA
1-Port 10-Gigabit Ethernet SPA
Port number information for t
hese SPAs was updated in
Chapter 2, “Overview: Cisco CRS-1 SPA Interface Processor.
Optics and compatibility information for these SPAs was updated
in Chapter 1, “SIP and SPA Product Overview.
OL-7113-02 April 2006 Information about the 8-Port OC-12c/
STM-4 Multirate POS SPA
was added to Chapter 3, “Overview: Cisco CRS-1 Shared Port
Adapters.
“Packing a SIP for Shipment” in
Chapter 7, “Troubleshooting the
Installation, was added.
OL-7113-01 July 2005 Initial release of the document.
Table 1 Changes to This Document
Revision Date Change Summary
Section Title Description
Chapter 1 SIP and SPA Product Overview Provides a brief introduction to the SPA interface
proc
essors (SIPs) and shared port adapters (SPAs).
Chapter 2 Overview: Cisco CRS-1 SPA
Interface Processor
Provides a SIP and SPA compatibility summary.
F
or each supported SIP, it provides a summary of
SIP characteristics and a SIP overview.
Chapter 3 Overview: Cisco CRS-1 Shared Port
Adapters
For each supported SPA, provides a summary of
SP
A characteristics and a SPA overview.
Chapter 4 Preparing to Install a SIP or a SPA Describes the required tools, equipment, and
safet
y guidelines for installing SIPs and SPAs.
Chapter 5 Installing and Removing a SIP Describes the procedures for installing and
remo
ving a SIP on the Cisco CRS-1 router.
Chapter 6 Installing and Removing a SPA Describes the procedures for installing and
remo
ving a SPA on the Cisco CRS-1 router. It also
descr
ibes how to verify the SIP and SPA
installation.
Chapter 7 Troubleshooting the Installation Provides information for troubleshooting the
i
nstallation of SIPs and SPAs. It also describes
helpful debug commands and error messages.

Table of Contents

Other manuals for Cisco CRS-1 - Carrier Routing System Router

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco CRS-1 - Carrier Routing System Router and is the answer not in the manual?

Cisco CRS-1 - Carrier Routing System Router Specifications

General IconGeneral
BrandCisco
ModelCRS-1 - Carrier Routing System Router
CategoryNetwork Router
LanguageEnglish

Related product manuals