Cisco IE 3000 Hardware Installation Guide

2-34
Cisco IE 3000 Switch Hardware Installation Guide
Chapter 2 Switch Installation
Installing the Switch
Note The 19-inch rack adapter is not intended for application in an industrial environment and therefore it will
not meet the environmental performance specifications for the Cisco IE 3000 switch.
To install the switch in a rack, follow these steps:
Step 1 Use the four Phillips machine screws to securely attach the brackets to the rack. See Figure 2-25.
Figure 2-25 Installing the DIN Rail on the Rack
Step 2 Follow the steps described in the Installing the Switch on a DIN Rail, page 27.
Warning To prevent bodily injury when mounting or servicing this unit in a rack, you must take special
precautions to ensure that the system remains stable. The following guidelines are provided to
ensure your safety:
• This unit should be mounted at the bottom of the rack if it is the only unit in the rack.
• When mounting this unit in a partially filled rack, load the rack from the bottom to the top with the heaviest
component at the bottom of the rack.
• If the rack is provided with stabilizing devices, install the stabilizers before mounting or servicing the unit in
the rack.
Statement 1006
201849

Cisco IE 3000 Specifications

General

Brand	Cisco
Model	IE 3000
Category	Switch
Language	English