4-24
Cisco PIX Security Appliance Hardware Installation Guide
78-15170-03
Chapter 4 PIX 515/515E
Installing the PIX 515/515E DC Model
Step 6 Insert the ground wire into the connector for the earth ground and tighten the screw on the connector.
Refer to Figure 4-24 and, using the same method as for the ground wire, connect the negative wire and
then the positive wire.
Note The DC return connection to this system is to remain isolated from the system frame and
chassis (DC-I).
Step 7 After wiring the DC power supply, remove the tape from the circuit breaker switch handle and reinstate
power by moving the handle of the circuit breaker to the ON position.
Step 8 Install any remaining interface boards as described in the “Installing a Circuit Board in the
PIX 515/515E” section on page 4-19.
Step 9 Power on the unit from the switch at the rear of the unit.
Note If you need to power cycle the DC PIX 515/515E, wait at least five seconds between powering off the
unit and powering it back on.
To Next Page
Loading...
Need help?
General
