Cisco PIX Series User Manual

5-11
Cisco PIX Security Appliance Hardware Installation Guide
78-15170-03
Chapter 5 PIX 520
Removing and Replacing the PIX 520 Chassis Cover
Step 4 Remove the chassis cover as shown in Figure 5-12.
Figure 5-12 Removing the Chassis Cover
Replacing the Chassis Cover
Caution Do not operate PIX security appliance units without the chassis cover installed. The chassis cover
protects the internal components, prevents electrical shorts, and provides proper air-flow for cooling the
electronic components.
To replace the chassis cover, perform the following steps:
Step 1 Replace the chassis cover, as shown in Figure 5-13.
Step 2 Secure the three screws.
Step 3 Reinstall all interface cables.
Figure 5-13 Replacing the Chassis Cover
PIX Firewall
S
E
R
IE
S
R
E
SE
T
10371
Pull lid 1 in. (50 mm)
back and then lift up
1 in.
PIX Firewall
S
E
R
IE
S
RE
SE
T
10380

Cisco PIX Series Specifications

General

Brand	Cisco
Model	PIX Series
Category	Network Hardware
Language	English