To Next Page

To Previous Page

Chapter 3

Setup

This Chapter provides Setup details of the Dual-Band Wireless-N VPN Router.

Configuration Program

The Dual-Band Wireless-N VPN Router contains an HTTP server. This enables you to connect

to it, and configure it, using your Web Browser. Your Browser must support JavaScript.

The configuration program has been tested on the following browsers:

• Netscape 7.1 or later

• Mozilla 1.6 or later

• Internet Explorer V5.5 or later

Preparation

Before attempting to configure the Dual-Band Wireless-N VPN Router, please ensure that:

• Your PC can establish a physical connection to the Dual-Band Wireless-N VPN Router.

The PC and the Dual-Band Wireless-N VPN Router must be directly connected (using the

Hub ports on the Dual-Band Wireless-N VPN Router) or on the same LAN segment.

• The Dual-Band Wireless-N VPN Router must be installed and powered ON.

• If the Dual-Band Wireless-N VPN Router's default IP Address (192.168.1.1) is already

used by another device, the other device must be turned OFF until the Dual-Band Wire-

less-N VPN Router is allocated a new IP Address during configuration.

Using your Web Browser

To establish a connection from your PC to the Dual-Band Wireless-N VPN Router:

1. After installing the Dual-Band Wireless-N VPN Router in your LAN, start your PC. If

your PC is already running, restart it.

2. Start your WEB browser.

3. In the Address box, enter "HTTP://" and the IP Address of the Dual-Band Wireless-N

VPN Router, as in this example, which uses the Dual-Band Wireless-N VPN Router's de-

fault IP Address:

HTTP://192.168.1.1

4. When prompted for the User name and Password, enter values as follows:

• User name admin

• Password admin

Cisco RV220W User Manual

Questions and Answers: