5
Physical Details
Front-mounted LEDs
POWER
(Green)
On - Power on.
Off - No power.
DIAG (Red) On - System problem.
Off - Normal operation.
Flashing - System rebooting or firmware upgrading.
DMZ (Green) On - DMZ enabled.
Off - DMZ disabled.
WIRELESS
(Green)
On - Wireless enabled.
Off - No Wireless connections currently exist.
Flashing - Data is being transmitting or receiving via the Wireless con-
nection.
LAN (1~4)
Each port has 3 LEDs:
• 10 - This will be ON if the LAN connection is using 10BaseT, and
blinking if data is being transferred via the corresponding LAN port.
• 100 - This will be ON if the LAN connection is using 100BaseT, and
blinking if data is being transferred via the corresponding LAN port.
• 1000 - This will be ON if the LAN connection is using 1000BaseT,
and blinking if data is being transferred via the corresponding LAN
port.
If neither LED is on, there is no active connection on the corresponding
LAN port.
WAN(Green) The WAN LED lights up the appropriate LED depending upon the speed
of the device that is attached to the Internet port. If the Router is connected
to a cable or DSL modem, typically the 10 LED will be the only LED lit
up (i.e. 10Mbps). The LED Flashes during activity.
To Next Page
Loading...
Need help?
General
