VLAN Management
Regular VLANs
Cisco 350, 350X and 550X Series Managed Switches, Firmware Release 2.4, ver 0.4 229
12
Configuration Guidelines
Note the following feature configuration guidelines:
• MSTP—All VLANs in a private VLAN must be assigned to the same MSTP instance.
• IP Source Guard—Binding an ACL on IP source guard ports with private VLAN is
not recommended due to the amount of TCAM resources needed.
Regular VLANs
This section describes the GUI pages used to configure various types of VLANs. This section
describes:
• Regular VLAN Overview
• VLAN Settings
• Interface Settings
• Port to VLAN
• Port VLAN Membership
• VLAN Translation
• GVRP Settings
• MAC-Based VLAN Group Overview
• Subnet-Based VLAN Groups Overview
• Protocol-Based VLAN Groups Overview
Regular VLAN Overview
VLAN Configuration Workflow
To configure VLANs:
STEP 1 Create the required VLANs as described in the VLAN Settings section.
STEP 2 Set the desired VLAN-related configuration for ports and enable QinQ on an interface as
described in the Interface Settings section.
To Next Page
Loading...
Need help?
General
